BIM Information Exchange Demonstration
JULY 23-25, 2008
CVIE Implementation Testing: Bentley
ProjectWise Navigator or Bentley Architecture
by Nicholas Nisbet MA (Cantab) DipArch (UNL) - AEC3 and William East, PE, PhD - Engineer Research and Development Center, U.S. Army Corps of Engineers
The following table provides the analysis conducted to evaluate software manufacturer compliance with the Coordination View Information Exchange (CVIE) conducted for the 23-25 July 2008 Building Information Modeling Information Exchange Demonstration.
The CVIE requirements include the provision of a clash detection report with each design deliverable. Hard- (physical co-location) and Soft- (using clearance distances) should be included in the clash analysis. To allow an independent analysis of clash detections the CVIE requirement also asks for a copy of the IFC 2x3 Coordination View file.
Bentley CVIE File using direct submission to report
||ProjectWise Navigator or Bentley Architecture
||ProjectWise Navigator 8.9.5 or Bentley Architecture 8.9.4
||Prototypical COBIE specific IFC customizations and OmniClass support.
|Coordination view file
|CVIE clash report
| Proxy component ratio
- 0.000 % = 0 / 4040 (good)
| Unnamed component ratio
- 0.000 % = 0 / 4040 (good)
| Interference report
| Interference record
- Clash number, coordinate, status, type
- Illustration of objects without context
| For each item
- (Sub-model) file i.e. "Steel-Framing -01"
- (Instance/Type) Family and Part i.e. "21 41 31 11 21 Structural Floor Columns" (an example of one of the two items reported on)
||The sample file submitted included architecture, spaces, sanitary, equipment and HVAC systems.
Some local software manufacturer sales representatives may not be familiar with the performance-based, open-standard information exchange formats tested during the July 2008 meeting. As a result, these sales representatives may not be able to assist your use of this format. It is suggested that users contact vendor technical support and request "higher tier" technical support services.
There are also several third-party support contractors who have been involved in the development of these formats that could be of assistance. For information about these contractors, please post a request for assistance on the buildingSMART alliance list service. You will need to join the Alliance to use this service.
Another resource that might be helpful is a peer-to-peer forum supporting the Model Support Group of the International Alliance for Interoperability's (www.iai-international.org). The purpose of this forum is to help users find and share answers to their own questions regarding IFC-based information exchanges. This forum was used during the vendor communications leading to the July 2008 demonstration; as a result vendor technical staff may be reviewing forum postings to support their users. You must register, and be approved, for this forum however use of the forum is free of charge, at this time.
Back to the BIM Information Exchange Demonstration